Oceanic VT3 - Set Turn Pressure Alarm

40
SET TURN PRESSURE ALARM (for Transmitter 1 only)
Information includes (Fig. 32):
> Graphic TURN
> Set Point OFF or a numeric value, flashing.
> Symbol PSI (or M)
 Pressing and releasing the S button momentarily (< 2
seconds) will step through the Set Points from OFF to 1000
to 3000 PSI (70 to 205 BAR) in 250 PSI (5 BAR)
increments.
 Depressing the S button will scroll through the Set Points at
a rate of 4 Set Points per second until it is released.
 Pressing and releasing the A button momentarily (< 2
seconds) will save the setting and/or advance to the SET
END PRESSURE ALARM screen with the Set Point flashing.
 Pressing and releasing the A button repeatedly (< 2
seconds each) will step through the other SET A screens.
 Depressing the A and S buttons simultaneously for 2
seconds will save the setting and revert to the SET A screen.
 Depressing the M button for 2 seconds or if no button is
pressed for a period of 2 minutes operation will revert to
the NORM or GAUG SURF MAIN screen.
Fig. 32 - Set Turn Alarm