EasyManua.ls Logo

Oceanic VT3 - Smartglo Backlight

Oceanic VT3
164 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
14
A single short beep (which cannot be disabled) is emitted for the following -
 Upon completion of a Hot Swap battery change.
 Change from Delayed to Full Violation 5 minutes after the dive.
3 short beeps (which cannot be disabled) are emitted for the following -
 FREE Dive Elapsed Dive T ime Alarm (3 beeps every 30 seconds if set On).
 FREE Dive Depth Alarms 1/2/3 (set sequentially deeper) - each 3 beeps 3 times.
 FREE Dive TLBG Alarm (Caution zone, 7 segments) - 3 beeps 3 times.
 Entry into Deco during a FREE Dive (Permanent Violation) - 3 beeps 3 times.
 Free Dive Mode Countdown Timer reaches 0:00 - 3 beeps 3 times.
During the following NORM Dive situations, the 10 second Audible Alarm will not turn off
when acknowledged -
 Ascending above a required Decompression Ceiling Stop Depth for more than 5
minutes (referred to as a Delayed Violation).
 Decompression requires a Ceiling Stop Depth of 70 FT/21 M or deeper.
 Being on the Surface for 5 minutes after a Conditional Violation.
SMARTGLO® BACKLIGHT
To activate the SmartGlo Backlight - press the S button.
 If ambient light level is low, the Backlight will activate and illuminate the display for
button depression time* plus the user set Duration time of 0, 5, or 10 seconds, for a
maximum of 20 seconds.
(*The Backlight will turn Off if the button is depressed for more than 10 seconds.)
 Press the button again to activate as desired.

Table of Contents

Related product manuals