Oceanic VT3 - SET WET ACTIVATION

44
SET WET ACTIVATION information includes (Fig. 36):
> Graphic WET
> Set Point graphic ON (or OFF) flashing.
 Pressing and releasing the S button will toggle between ON
and OFF.
 Pressing and releasing the A button momentarily (< 2
seconds) will save the setting and/or advance to the SET
UNITS screen with the Set Point flashing.
 Pressing and releasing the A button repeatedly (< 2
seconds each) will step through the other SET U screens.
 Depressing the A and S buttons simultaneously for 2
seconds will save the setting and revert to the SET U screen.
 Depressing the M button for 2 seconds or if no button is
pressed for a period of 2 minutes operation will revert to
the NORM or GAUG SURF MAIN screen.
HINT: To change this setting while operating in
FREE Mode, first access the NORM SURF Mode.
Fig. 36 - Set Wet Activation