55
SET TMT 3 (or BUD 2)
information includes (Fig. 45):
> Graphics TMT3 (or BUD2), and ON (or OFF) flashing.
> Set Point (T ransmitter's Serial Number (Link Code)).
Pressing and releasing the S button momentarily (< 2
seconds) will toggle between ON and OFF.
Pressing and releasing the A button momentarily (< 2
seconds) will accept the ON/OFF selection.
If OFF is selected, operation reverts to the SET U screen.
If ON is selected, the first (left) digit of the Code will flash.
Pressing and releasing the S button repeatedly (< 2 seconds
each time) will increase the First Digit from 0 to 9 in
increments of 1.
Depressing the S button will scroll through the Set Points at
a rate of 4 per second.
Pressing and releasing the A button (< 2 seconds) will
accept the First Digit of the Code and/or advance to the
Second Digit which will be flashing.
Pressing and releasing the S button will increase the Second
Digit from 0 to 9 in increments of 1.
Depressing the S button will scroll through the Set Points at
a rate of 4 per second.
Pressing and releasing the A button (< 2 seconds) will
accept the Second Digit of the Code and/or advance to the
Third Digit which will be flashing.
Fig. 45 - Set TMT 3
If TMT 2-3 USE is set for
SELF (Gas Switching)
If TMT 2-3 USE is set for
Buddy Pressure Check
- OR -
To Next Page
Loading...
