1 – 6
Self Adjust Function
The self adjust function maintains the correct head gap setting and improved print
quality.
When the printer is powered up without paper, the printer starts the self adjust cycle
automatically after initialisation.
Use this function regularly when rear or bottom paper feed is used, and approximately
every one box or 2000 sheets.
Note: The printer ribbon must be installed before the self adjust function
is performed.
• Switch on the printer, the Power/ALARM lamp comes on and the printhead
assembly moves to its home position.
• The Print Quality/Character Pitch lamp comes on.
• The Self Adjust cycle starts.
Note: Before replacing your printers ribbon deselect the printer, this will
centre the printhead (approximately two seconds) and maximise the head
gap (position 9). Once this has been done the old ribbon can be removed
and the new ribbon installed.
☞
☞
To Next Page
Loading...
Need help?
General