1 ā 14
Running a Self Test
After you have installed the ribbon and loaded paper, you are ready to run either of the
two self tests. These tests allow you to check that your printer is functioning properly.
Holding down the QUIET/TOF button while switching the printer ON produces a
continuous sample of the default print style.
Note: This sample prints along the entire length of the platen, so be sure
to use wide paper when running this test.
Holding down the LF button while turning the printer ON produces a limited sample
of each available print style.
ā
F/W 03.03
When complete (three pages), the printer stops and the SEL lamp comes on.
To terminate either of these two self-tests, press the SEL button. This will return the
printer to its ready state and the SEL lamp will be lit.
ML591Elite IE E F/W 05.00 YR4084-3066-06
CG 03.01
ML591Elite IE E F/W 05.00 YR4084-3066-06
CG 03.01
To Next Page
Loading...
Need help?
General