EasyManua.ls Logo

Oki MICROLINE 591Elite - Printable Area

Oki MICROLINE 591Elite
126 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
1 – 10
Printable Area
The default top margin when using single sheets is 0.35 inch (8.89mm). However, the
top of form position can be adjusted by micro feed in steps of
1
¦180 inches to a minimum
position of 0.02 inches (0.5mm) from the top edge of the paper.
The bottom margin defaults to 0.5 inches (12.7mm) with Bottom Margin Valid set in
the menu. If this menu item is set to Invalid, the bottom margin will be controlled by
the Page Length setting, and will allow printing to a minimum distance of 0.02 inches
(0.5mm) from the bottom edge of the page.
Note: Care should be exercised to ensure that the correct page length
setting is selected when the Bottom Margin Invalid option is chosen, as
overprinting on to the platen roller could occur, damaging both the
printhead and the roller.
0.5 inch bottom
margin default
(12.7mm)
Printable area
0.35 inch top
margin default
(8.89mm)
Additional Area
Additional Area
0.02 inch
minimum
(0.5mm)
0.02 inch
minimum
(0.5mm)
0.16
inch
(4.1mm)
0.12
inch
(3.0mm)

Table of Contents

Related product manuals