2 – 4
Print Characteristics
The print quality and character pitch buttons let you control basic printing features
through your printer’s control panel:
1. Press the SEL button (SEL light goes out).
2. Press the features that you wish to change (light goes on).
3. Press the SEL button.
The panel always indicates the actual settings of the printer. If you change any of these
features through your software, the panel lights will also change to reflect this feature
choice.
The panel will only allow you to select valid combinations of features. For example,
proportional spacing can only be selected when the print quality choice is set to LQ.
The two printing features available on the control panel offer the following selection
of modes:
Print Quality
There are seven resident fonts which can be selected on your printer. For an example
of each please refer to the self test print out.
COURIER
ROMAN
GOTHIC
SWISS BOLD
SWISS
PRESTIGE
UTILITY
To Next Page
Loading...
Need help?
General