2 – 1
Operation
2
PRINT QUALITY
CHARACTER PITCH
LF FF/LOAD
TEAR PARK QUIET
SEL
MENU
SHIFT
Micro Feed
Down
Micro Feed
Up
EXIT
POWER
ALARM
TOF
GROUP ITEM
SET
PRINT
LQ
UTILITY
COURIER
PRESTIGE
GOTHIC
BOLD
ROMAN
SWISS
10
17
12
20
15
PROP
RESET
SEL
MENU
Using the Control Panel
The control panel puts many of your printer’s functions within reach of your fingertips.
It even lets you customise your printer for special applications without programming.
Experiment with these controls and you will see how much your printer can do and how
easy it is to use. The next few pages explain the basics of using the control panel.
Basic Controls
POWER light: Lit when On.
ALARM light: Lit to indicate alarm condition: paper out, paper jam, cover open.
LF button: Moves paper up one line (when printer is selected or deselected). If a CSF
is installed on the printer, pressing the LINE FEED button will cause a single sheet to
be inserted when there is no paper in the printer.
FF/LOAD button: Advances paper to the top of the next page (when printer is selected
or deselected). When bottom or rear feed is selected, the paper is loaded from the
tractor.
SHIFT and QUIET/TOF button: When the printer is deselected this button sets the
position of the Top Of Form. The TOF setting is not effective in single sheet mode.
SEL button: Selects or deselects the printer. When selected, the printer is ready to
receive data; when deselected, it will not print. Pressing this button during a self-test
will terminate the test and return the printer to its ready state.
SEL lamp: Lights when printer is selected (ready to receive data); goes out when it is
deselected. The light blinks when the printer is in Print Suppress mode (refer to the
Menu Settings for more details).
To Next Page
Loading...
Need help?
General