4 – 3
Absolute Vertical Decimal Hex ASCII Comp
Print Position
Set Absolute Vertical 27 40 86 Ln 1B 28 56 Ln ESC ( V Ln E2
Print Position Hn Lp Hp Hn Lp Hp Hn Lp Hp
Ln and Hn: Length of the following parameters calculated by
Ln + Hn x 256.
(MSB of Hn is ignored.)
Normally Ln = 2, Hn = 0.
Print position moves vertically position from the current top margin position, as shown
in the following table:
(Lp + Hp x 256) data valid area table
Unit (inch)
1
/360
1
/180
1
/120
1
/90
1
/72
1
/60
Area 0000-40FF 0000-207F
0000-15AA 0000-103F 0000-0CFF 0000-0AD5
Font selection Decimal Hex ASCII Comp
This selects the pitch and point as follows:
1. Pitch
Pn = 0 No pitch change
Pn = 1 Proportional
2 ≤ Pn ≤ 4 Invalid
Pn ≥ 5 Pitch = Pn/360
2. Point
Lp+Hp x 256 (0-32767) Point
0 No change*
1-17 8
18-19 8
20 10
21 10.5
22-23 11
24-25 12
26-125 (step 2) 13-62 (step 1)
126-127 63
128-32767 64
* If point selection is reset, it selects the current CPI font, otherwise there will be no
change in size.
Set Font By Pitch 27 88 Pn Lp Hp 1B 58 Pn Lp Hp ESC X Pn Lp E2
And Point size Hp
To Next Page
Loading...
Need help?
General