2 – 14
Explanation of menu items
Emulation Mode: Select the printer command set you want your printer to use.
Choose Epson LQ series or IBM PPR or AGM.
Print Mode: Choose LQ for Letter Quality printing, Utility for quicker printing.
Pitch: Choose character width measured in characters per inch (CPI), or proportionally
spaced characters.
Style: Choose Normal (upright) or Italics (slanted).
Size: Choose Single or Double width and height.
Character Set: Choose IBM Character Set 1 or Set 2 as the default character set.
Language Set: These sets replace certain symbols with special characters used in the
respective foreign languages (see National Character Sets in Appendix B).
Zero Character: Choose Slashed when it is important to distinguish between a zero
(0) and a capital letter O.
Code Page: This option is available in both IBM and EPSON emulation. This allows
several character sets containing special characters to be accessed using the format
which selects IBM Character Sets 1 and 2 and the All Character Set.
Slashed letter O: Character ¢ (155) and ¥ (157) will be set to ø and Ø if set to YES.
Line Spacing: Choose 6 lines per inch (1/6 inch line spacing) or 8 LPI (1/8 inch
line spacing).
Form Tear Off: Use this option to turn the forms tear off feature ON or OFF or to allow
a wait time after a form feed occurs. When it is set to off, if the printer receives a FF
or end of page is reached and there is no more data, the paper is fed to the TOF position
and the printer is deselected. After the sheet has been removed the user should push the
SEL switch to resume or start a print job. The default setting is OFF.
To Next Page
Loading...
Need help?
General