Okuma OSP-P20L - Page 185

5238-E P-172
SECTION 8 LATHE AUTO-PROGRAMMING FUNCTION (LAP)
(7) AP Mode II, Transverse Cutting Mode (G86 + G82 + G80)
LE33013R0301000030017
(8) AP Mode III, Transverse Cutting Mode (G88 + G82 + G80)
LE33013R0301000030018
(9) AP Mode IV, Transverse Cutting Mode (G85 + G83 + G82 + G80) (LAP4 only)
LE33013R0301000030019