Okuma OSP-P20L - Page 347

5238-E P-334
SECTION 15 APPENDIX
G124 Chuck A origin effective ✩
G125 Chuck B origin effective ✩
G126 Slope machining mode OFF command ✩
G127 Slope machining mode ON command ✩
G128 M/C machining mode OFF command ✩
G129 M/C machining mode ON command ✩
G130
G131
G132 Circular interpolation in contour generation (Side)(CW) ✩
G133 Circular interpolation in contour generation (Side)(CCW) ✩
G134
G135
G136 End of coordinate conversion or Y-axis mode OFF ✩
G137 Start of coordinate conversion ✩
G138 Y-axis mode ON ✩
G139
G140 Designation of machining mode using main spindle ✩
G141 Designation of machining mode using sub spindle ✩
G142 Designation of machining mode using pick-off spindle ✩
G143 Designation of machining mode using pick-off spindle and 3rd turret ✩
G144 W-axis control OFF command ✩
G145 W-axis control ON command ✩
G146
G147
G148 B-axis mode OFF command ✩
G149 B-axis mode ON command ✩
G150
G151
G152 Programmable tailstock positioning (tow-along tailstock) ✩
G153 Programmable steadyrest G code (tow-along) ✩
G154 W-axis unidirectional positioning command ✩
G155 Accurate contouring mode ON command ✩
G156 Accurate contouring mode OFF command ✩
G157
G158 Tool length offset in tool axis direction ✩
G159 Tool length offset in tool axis direction (without rotary position offset) ✩
G160 Tool length offset in tool axis direction cancel
G161 G code macro function MODIN ✩
G162 G code macro function MODIN ✩
G163 G code macro function MODIN ✩
G164 G code macro function MODIN ✩
G165 G code macro function MODIN ✩
G166 G code macro function MODIN ✩
G167 G code macro function MODIN ✩
G Code Contents