5238-E P-333
SECTION 15 APPENDIX
G80 End of shape designation (LAP) ✩
G81 Start of longitudinal shape designation (LAP) ✩
G82 Start of transverse shape designation (LAP) ✩
G83 Start of blank material shape definition (LAP) ✩
G84 Change of cutting conditions in bar turning cycle (LAP) ✩
G85 Call of rough bar turning cycle (LAP) ✩
G86 Call of rough copy turning cycle (LAP) ✩
G87 Call of finish turning cycle (LAP) ✩
G88 Call of continuous thread cutting cycle (LAP) ✩
G89
G90 Absolute programming
G91 Incremental programming
G92
G93
G94 Feed per minute mode (mm/min)
G95 Feed per revolution mode (mm/rev)
G96 Constant speed cutting ON
G97 Cancel of G96
G98
G99
G100 Priority designating for turret A or B independent cutting ✩
G101 Linear interpolation in contour generation ✩
G102 Circular interpolation in contour generation (Face) (CW) ✩
G103 Circular interpolation in contour generation (Face) (CCW) ✩
G104
G105
G106
G107 Spindle synchronization tapping, RH thread ✩
G108 Spindle synchronization tapping, LH thread ✩
G109
G110 Constant speed cutting on turret A
G111 Constant speed cutting on turret B
G112 Circular thread cutting CW ✩
G113 Circular thread cutting CCW ✩
G114
G115
G116
G117
G118
G119 Nose-R compensation: C-X-Z plane ✩
G120
G121
G122 W-axis command for sub spindle on turret A (G13) ✩
G123 W-axis command for sub spindle on turret A (G14) ✩
G Code Contents
To Next Page
Loading...