5238-E P-338
SECTION 15 APPENDIX
M36 Loader gripper Z slide advance ✩
M37 Loader arm retract ✩
M38 Loader arm advance to unloading position ✩
M39 Loader arm advance to chuck position ✩
M40 Spindle gear range neutral
M41 Spindle gear range 1 or low-speed winding selection
M42 Spindle gear range 2 or high-speed winding selection
M43 Spindle gear range 3
M44 Spindle gear range 4
M45
M46
M47
M48 Spindle speed override ignore cancel ✩
M49 Spindle speed override ignore ✩
M50 Additional air blower 1 OFF ✩
M51 Additional air blower 1 ON ✩
M52
M53
M54 Automatic indexing of index chuck ✩
M55 Tailstock spindle retract ✩
M56 Tailstock spindle advance ✩
M57 cancel of M63
M58 Chucking pressure low
M59 Chucking pressure high
M60 Cancel of M61
M61 Ignoring fixed rpm arrival in constant speed cutting
M62 Cancel of M64 ✩
M63 Ignoring spindle rotation M code answer ✩
M64 Ignoring general M code answer ✩
M65 Ignoring T code answer ✩
M66 Turret indexing position free ✩
M67 Synchronized mode cancel in cam turning cycle ✩
M68 Synchronized mode A ON ✩
M69 Synchronized mode B ON ✩
M70 Manual tool change command ✩
M71
M72 ATC unit positioning at approach position ✩
M73 Thread cutting pattern 1 ✩
M74 Thread cutting pattern 2 ✩
M75 Thread cutting pattern 3 ✩
M76 Parts catcher retract ✩
M77 Parts catcher advance ✩
M78 Steady rest unclamp ✩
M79 Steady rest clamp ✩
M Code Contents
To Next Page