• Place control lever in
"LO"
or
"HI"
for
continous operation
at
the
selected
speed.
• Return switch
to
"OFF"
to
stop wiper
operation and
to
park
the
wipers in the
concealment recess.
• For a single wiping cycle, move lever
to
"MIST" position, hold until wipers
move out
of
park position and begin
wiping, then release lever. Blades re-park
after one cycle. For several cycles, hold
lever in
"MIST" as long as necessary.
• Press wiper control lever and release
to
activate
"10"
wiper speed and
to
direct
a quantity
of
washer fluid
to
the
windshield.
Move
wiper lever
to
"OFF"
after wash cycle
is
completed.
Operating Tips:
• Check the washer fluid level regularly -
do
it
often when the weather
is
bad.
•
Use
a fluid such
as
GM
OPTIKLEEN
to
help prevent freezing damage, and for
better cleaning.
.
•
Do not use radiator antifreeze in the
30
windshield washer; it could cause paint
damage.
•
In
cold weather, warm
the
windshield
with defrosters before using washer,
to
help prevent icing
that
may block the
driver's vision.
PU
LSE
WIPER
SYSTEM
This pulse windshield wiper (optional)
permits the driver
to
control
the
wipe cycle
from a sixteen second maximum delay
interval up
to
the regular low and high
speeds on a standard wiper.
To
operate
wipers with variable delay between wiper
sweeps,
move sliding lever
to
the
''DELAY'' position. Rotate the knob
to
control
the amount
of
delay. For
continuous operation, place lever
in
"LO"
or
"HI".
Push the knob
to
obtain ''WASH''
action.
The wipers will automatically go
to
park
position or return
to
the action for which
the knob was set after completing
the
''WASH'' cycle.
SPEEDOMETER
AND
ODOMETER
The speedometer shows the forward speed
of
the car
in
· miles per hour. The odometer
registers the accumulated mileage the car
has been driven.
TRIP
METER
The trip meter (optional) may be reset
by
pushing in
the
reset knob (located in
the
speedometer face) and turning it clockwise
until all
the
zeros appear.
ELECTRIC
CLOCK
The
electric
clock
(optional)
is
automatically regulated
to
compensate for
lost
or
gained time whenever
the
clock
is
reset.
If
the clock
is
running fast, set the
hands back (counterclockwise);
if
running
slow, set hands forward (clockwise).
Several
resettings, several days apart, may
be needed
to
properly adjust
the
clock
mechanism for any major correction.
To Next Page
Loading...
Need help?
General
