Optional Equipment
OPERATION GUIDE 7-5
NOTE: Check to make sure that there are no originals remaining on the
Original Table or on the Original Eject Table before opening the Document
Processor. Originals left there may fall out when the Document Processor
is opened.
2
Place the side to be copied so that
it faces down. At this time, adjust
the Original Size Indicator Plate to
match the size of the original.
3
Shut the Document Processor by grasping the Document Processor Open/
Close handle.
IMPORTANT: Do not use excessive force to press the Document
Processor onto the platen. The platen glass may break if excessive force
is used.
CAUTION: Do not leave the copier with the Document Processor
open. Doing so may lead to injuries.
Mixed Original Sizes Mode
When the original size has not
been specified using [Mixed
Original Size] while using the
Document Processor, the original
sizes are detected one by one and
each original is automatically
copied to a sheet of the same
size.
IMPORTANT: The maximum
number of sheets that can be set
in the Document Processor in this
mode is 30 sheets.
[Inch specifications]
Only Letter R and Ledger, or
Legal and Letter sizes.
[Metric specifications]
Only A4 and A3, B5 and B4, or
A4R and Folio sizes.
11" 17"
(A3)
11" 8
1/2
"
(A4)
8
1/2
" 14"
(Folio)
8
1/2
" 11"
(A4R)
B4 B5
To Next Page
Loading...
Need help?
General