Optional Equipment
7-4 OPERATION GUIDE
2
Place the originals to be copied
with the side to be copied facing
up (in the case of 2-Sided copies,
place them with the Front side
facing up) and place them in order
on the Originals Table.
IMPORTANT: Set the originals
below the scale gradation pasted
on the rear original width guide.
Setting more than the acceptable
number of originals may lead to
the originals jamming. (Refer to
Originals that can be used with
the Document Processor on page
7-2 for the number of originals that
can be set.)
When setting Ledger, Legal, A3 or
B4 originals open the Ejection
Extension to prevent the originals
from falling after ejection.
In the case of Front and Back
originals, the originals will be turned over so the originals will be
temporarily ejected into the Ejection Tray. Do not handle the originals
during this temporary ejection. Trying to pull an original out by force may
cause a paper misfeed.
Setting the Original on the Platen
When copying items such as books or magazines that cannot be set in the
Document Processor, open the Document Processor and place the
original on the platen.
1
Open the Document Processor by
grasping the Document
Processor Open/Close handle.
To Next Page
Loading...
Need help?
General