n If your computer is IBM PC/AT compatible running Windows 98/98 Second
Edition, install the USB driver on your computer beforehand. For
installation, refer to the USB driver’s installation guide (or the CAMEDIA
Master’s one, when using the CAMEDIA Master).
n If your computer is Apple Macintosh which is running Mac OS 8.6 (or
higher), make sure the USB support version is USB MASS Storage Support
1.3.5 (or higher).
1
Open the camera’s connector
cover.
2
Connect the end of the USB cable
marked A to the USB connector
on the personal computer.
3
Connect the end of the USB cable
marked B to the USB connector
on the camera.
195
11
Connecting to a computer
USB port
USB connection
cable
Camera’s USB
connector
Connecting to a computer using the exclusive
USB cable
This section explains how to save image data to a personal computer by
connecting it to the camera with the exclusive USB cable.
Transfer methods vary depending on the computer operating environment.
[ Connecting directly to a computer by cable (P. 00)
To Next Page
Loading...
