Olympus CV-180 - Page 256

248
Chapter 9 Function setup
EVIS EXERA II VIDEO SYSTEM CENTER CV-180
 Position of the PinP sub image
Click the check box for the position to display the PinP sub image. The selected
check box turns black.
Figure 9.43
 Display mode of PinP
1. Click “ ” of “Movement” (see Figure 9.41).The PinP modes appear in the
pull-down menu.
2. Click the desired PinP mode. The selected PinP mode is displayed.
3. Click “ ” of “Mode” if “ON/OFF” of “Movement” is selected (see Figure
9.41). The display modes appear in the pull-down menu.
Setting value
Explanation (see “PinP (picture in picture) display” on
page 64.)
On/Off The PinP button toggles back and forth between the non-PinP
mode and the PinP mode.
Mode change The PinP button switches between the PinP mode, endoscopic
image and external image.
Table 9.49
Setting value Explanation
SCOPE/aux. The endoscopic image is the main image and the external image
is the sub image.
AUX./scope The external image is the main image and the endoscopic image
is the sub image.
Table 9.50
The highlighted check box shows
the position of the sub image
AB
CD
D
AB
C