Omron 3G3MX2 Series - Page 107

6 Drive Programming Commands
6 - 6
Drive Programming User’s Manual (I580-E2)
Conditions
Command Argument 1 Argument 2 Argument 3 Argument 4 Argument 5 Description
Condition
<variable 1/
constant>
 <variable 2/
constant>
TRUE if <variable
1/constant> is equal to
<variable 2/constant>.
<variable 1/
constant>
< <variable 2/
constant>
TRUE if <variable
1/constant> is less
than <variable 2/
constant>.
<variable 1/
constant>
< <variable 2/
constant>
TRUE if <variable
1/constant> is equal to
or less than <variable
2/constant>.
<variable 1/
constant>
> <variable 2/
constant>
TRUE if <variable
1/constant> is greater
than <variable 2/
constant>.
<variable 1/
constant>
> <variable 2/
constant>
TRUE if <variable
1/constant> is equal to
or greater than <vari-
able 2/constant>.
<variable 1/
constant>
<> <variable 2/
constant>
TRUE if <variable
1/constant> is not
equal to <variable
2/constant>.
Arithmetic Operation and Logical Operation Commands
Command Argument 1 Argument 2 Argument 3 Argument 4 Argument 5 Description
Arithmetic
operation
<variable 1> : 
<variable 2/
constant>
Assigns <variable
2/constant> to <vari-
able 1>.
<variable 1> : 
<variable 2/
constant>
 <variable 3/
constant>
Adds <variable 2/con-
stant> and <variable
3/constant> and
assigns the result to
<variable 1>.
<variable 1> : 
<variable 2/
constant>
 <variable 3/
constant>
Subtracts <variable
3/constant> from
<variable 2/constant>
and assigns the result
to <variable 1>.
<variable 1> : 
<variable 2/
constant>
* <variable 3/
constant>
Multiplies <variable
2/constant> by <vari-
able 3/constant> and
assigns the result to
<variable 1>.
<variable 1> : 
<variable 2/
constant>
/ <variable 3/
constant>
Divides <variable
2/constant> by <vari-
able 3/constant> and
assigns the result to
<variable 1>.