4 - 27
4 Drive Programming Editor
Drive Programming User’s Manual (I580-E2)
4-10 Executing Programs (Drive Programming Function Selection)
4
When A017 is set to 02, stop the running program that was started at power ON before you
restart the program via the CX-Drive.
If any program that was started at power ON is running, the CX-Drive cannot restart the program.
In the CX-Drive, if you click the button to start the program when inverter is already in opera-
tion, the following message will be displayed in the final step.
"The program is running, so it cannot be transferred to the drive."
If you click [OK] here, the program is started forcibly regardless of the operation status of the
inverter.
Before you start the program, check the status of the equipment and ensure safety.
To Next Page
Loading...
