Omron 3G3MX2 Series - Page 95

5 Drive Programming User Variables
5 - 16
Drive Programming User’s Manual (I580-E2)
Use this function to monitor the inverter's total number of faults. The monitored data is equivalent to the
data of the Fault Counter (d080). This variable is read-only.
Use this function to monitor the data of the last six trips of the inverter. The monitored data is equivalent
to the data of the Fault Monitor 1 to 6 (d081 to 086). This variable is read-only. The trip data is displayed
with a code, which is the same as that in the Inverter Fault Monitor Factor List used in the inverter's
Modbus communications.
Use this function to monitor the inverter's internal DC voltage. The monitored data is equivalent to the
data of the DC Voltage Monitor (d102). This variable is read-only.
Use this function to monitor the inverter's status.
Each bit corresponds to the following status. This variables is read-only.
Function
variable
Description Data range
Default
data
Unit Data size R/W
ERR-CNT Fault Counter (d080) 0 to 65,535  Times Unsigned
1 word
R
Function
variable
Description Data range
Default
data
Unit Data size R/W
ERR(1) to
ERR(6)
Fault Monitor 1 to 6 (d081
to 086)
0 to 127 Unsigned
1 word
R
Function
variable
Description Data range
Default
data
Unit Data size R/W
DCV DC Voltage Monitor
(d102)
0 to 10,000  0.1 V Unsigned
1 word
R
Function
variable
Description Data range
Default
data
Unit Data size R/W
STATUS Inverter status monitor Unsigned
1 word
R
bit 0: Run
bit 1: Trip
bit 2: Reserve
bit 3: Retry
bit 4: Overload suppression
bit 5:
Overcurrent suppression
bit 6: Overvoltage suppression
bit 7: Reset
bit 8: Undervoltage
bit 9 to 15: Reserve