Omron CJ - PROGRAMMING MANUAL 12-2009 - Page 278

238
Manipulating Files Section 5-2
Supported File Transfer
Combinations
The following tables list whether files are automatically transferred to the CPU
Unit at startup depending on which files are present on the Memory Card.
■ Program File: AUTOEXEC.OBJ
■ Program File: REPLACE.OBJ
■ No Program File
■ Both AUTOEXEC and REPLACE Files
More Than One Program File
Program file Parameter area
file
Data files Transferred/
Not transferred
AUTOEXEC.OBJ AUTOEXEC.STD One or more of the following: AUTOEXEC.IOM,
ATEXECDM.IOM, ATEXECE@.IOM
Transferred.
None
None One or more of the following: AUTOEXEC.IOM,
ATEXECDM.IOM, ATEXECE@.IOM
Not transferred.
None
Program file Parameter area
file
Data files Transferred/
Not transferred
REPLACE.OBJ Present One or more of the following: REPLACE.IOM,
REPLCDM.IOM, REPLCE@.IOM
Transferred, but
parameter area
file is not trans-
ferred.
None
None One or more of the following: REPLACE.IOM,
REPLCDM.IOM, REPLCE@.IOM
Transferred.
None
Program file Parameter area
file
Data files Transferred/
Not transferred
None AUTOEXEC.STD One or more of the following: AUTOEXEC.IOM,
ATEXECDM.IOM, ATEXECE@.IOM
Not transferred.
One or more of the following: REPLACE.IOM,
REPLCDM.IOM, REPLCE@.IOM
None
None One or more of the following: AUTOEXEC.IOM,
ATEXECDM.IOM, ATEXECE@.IOM
One or more of the following: REPLACE.IOM,
REPLCDM.IOM, REPLCE@.IOM
Program files Parameter area
file
Data files Transferred/
Not transferred
AUTOEXEC.
OBJ
REPLACE.
OBJ
AUTOEXEC.STD One or more of the following: AUTOEXEC.IOM,
ATEXECDM.IOM, ATEXECE@.IOM
Not transferred.
One or more of the following: REPLACE.IOM,
REPLCDM.IOM, REPLCE@.IOM
None
None One or more of the following: AUTOEXEC.IOM,
ATEXECDM.IOM, ATEXECE@.IOM
One or more of the following: REPLACE.IOM,
REPLCDM.IOM, REPLCE@.IOM