11
Operating Modes Section 1-4
1-4-3 Startup Mode
Refer to the Operation Manual for details on the Startup Mode setting for the
CPU Unit.
Note The CPU Unit will start in RUN Mode if the PLC Setup's Mode Setting is set to
Use Programming Console but a Programming Console is not connected.
Note With CS1G/H-CPU@@(-V1) and CJ1@-CPU@@ CPU Units, the CPU Unit will
start in PROGRAM mode.
Conditions CS1-H/CJ1-H/CJ1M/
CS1D CPU Unit
CS1G/H-CPU@@(-V1)
and CJ1@-CPU@@
CPU Units
The PLC will start in the mode
shown at the right if both of the fol-
lowing conditions are met.
1. The PLC Setup is set to start PLC
operation in the mode set on the
Programming Console (Use Pro-
gramming Console), but a Pro-
gramming Console is not
connected.
2. A Programming Console is not
connected.
RUN mode PROGRAM mode
To Next Page
Loading...
