Omron CJ - PROGRAMMING MANUAL 12-2009 - Page 413

373
PLC Comparison Charts Appendix A
Interrupts I/O interrupts Yes (Max 2 Interrupt Input
Units: 32 points, plus 4 points
for built-in I/O on CJIM CPU
Units) (CJ1 CPU Units do not
support I/O interrupts.)
Yes (Max. 4 or
2 Interrupt
Input Units:
32 points)
Yes (Max. 2
Interrupt Input
Units: 16
points)
Yes (Max. 4
Interrupt Input
Units: 32
points)
Yes (4 built
into CPU Bus
Unit)
Scheduled interrupts Yes Yes Yes Yes
One-shot timer inter-
rupts
No No No Yes
Input interrupts in
counter mode
No No Yes No No No Yes
High-speed counter
interrupts
No No Yes No No No Yes
External interrupts Yes (See note 1.) Yes No No No
From Communica-
tions Board
No Yes Yes No No
Power-ON interrupt No No Yes No
Power-OFF interrupt Yes No Yes No
Interrupt response
time
0.17 ms
Built-in I/O on CJ1 CPU Units:
0.12 ms
C200H Spe-
cial I/O Unit:
1ms
CJ-series I/O:
0.1 ms
1 ms --- Approx.
0.1 ms
PLC Setup Area No user addresses (Setting is possible from
CX-Programmer or Programming Console.)
Fixed DM
Area alloca-
tion: DM 6600
to DM 6655,
DM 6550 to
DM 6559.
Setting possi-
ble from Pro-
gramming
Console.
No user
addresses
(setting possi-
ble only from
Programming
Device,
including par-
tially from
Programming
Console)
Fixed DM
Area alloca-
tion: DM 6600
to DM 6655.
Setting possi-
ble from Pro-
gramming
Console.
Item CJ1-H/CJ1M Series CS1-H Series C200HX/HG/
HE
CVM1/CV
Series
CQM1H
CJ1-H-R CJ1-H CJ1-M