What to do if I see a memory error on my Omron Temperature Controller?
If you encounter a memory error on your Omron Temperature Controller, first turn the power off and then back on. If the display remains the same, the unit requires repair. However, if the display is restored, investigate potential external noise affecting the control system.
What to do if my Omron E5GN Temperature Controller displays an HB error?
If your Omron Temperature Controller shows an HB error, begin by turning the power off, then on again. Should the display persist with the same error, the controller needs repair. If the display returns to normal, examine the system for electrical noise.
How to troubleshoot an input error on an Omron Temperature Controller?
If you're experiencing an input error with your Omron Temperature Controller, check the wiring of the inputs for any miswiring, disconnections, or short-circuits. Also, verify the input type.
Covers dimensions, panel cutout, mounting, and terminal plate handling.
Details terminal arrangements, wiring instructions, and precautions.
Illustrates typical setup procedures for common operating scenarios.
Guides on selecting the correct sensor input type for the controller.
Explains the ON/OFF control mode and hysteresis settings.
Guides on auto-tuning, self-tuning, and manual PID parameter setup.
Adjusts input sensor readings using one-point or two-point shift methods.
Covers parameters for PID tuning, input shifts, and control adjustments.
Configures basic settings like input type, temperature units, and control methods.
Provides access to advanced functions, parameter initialization, and detailed settings.
Step-by-step guide for calibrating thermocouple inputs.
Procedure for calibrating analog input signals (0-50 mV).
Detailed steps for calibrating PRT inputs.
General| Size | 48 x 48 mm |
|---|---|
| Number of Control Outputs | 1 |
| Number of Alarms | 2 |
| Type | Temperature Controller |
| Control Method | ON/OFF, PID control |
| Input Type | Thermocouple, RTD, Analog Current, Analog Voltage |
| Output Type | Relay, Voltage (for SSR drive), Current |
| Display | LED |
| Power Supply | 100-240 VAC |
| Communication | RS-485 (optional) |
| Control Output | Relay, Voltage (for SSR drive), Current |
| Alarm Output | Relay |
| Ambient Operating Temperature | -10 to 55 °C |
| Ambient Operating Humidity | 25 to 85% RH (non-condensing) |
| Protection Rating | IP66 |
| Dimensions | 48 x 48 x 78 mm |
| Weight | Approx. 200 g |
To Next Page
