APPENDIX
E5GN
A–12
Advanced function setting level
Parameter initialize
Standby sequence reset method
Reset conditions after standby sequence
is canceled.
Alarm 1 open in alarm
Set the alarm output 1 ON/OFF states.
Alarm 1 hysteresis
MultiĆSP uses
Protect level
Operation/adjustment protection
Restricts display and modification of menus
in the operation and adjustment levels.
Initial setting/communications protection
Restricts display and modification of menus
in the initial setup, operation level and adjust-
ment levels.
Setting change protection
Protects changes to setups by opera-
tion of the front panel keys.
ST stable range
Set the deviation.
Advanced PID parameter
MV upper limit
Limited to MV cal-
culation value
MV lower limit
Input digital filter
Set the time constant in seconds.
Additional PV display
Displayed first in the operation level.
Manipulated variable display
Move to calibration level
Automatic return to operation level when
the keys on the front panel are operated.
Automatic return of display mode
α
Communications setting level
Communication
unit No.
Communications setup on other party
personal computer is different.
Parity
Baud rate
Data bit
Stop bit
SP ramp set value
Alarm 1 latch
Protect level move time
Output input error
Cold junction compensation method
MB command logic switching
To Next Page
Loading...
