Onkyo NC-500

Other Information
61
Configuring Various Settings
Client Settings:
From the “System” → “Ethernet Settings” →
setup menu, select “Client” using the Cursor
/ button. Then press the SELECT button.
• Specifying the client name (a name
used to identify your NC-500 on the
network)
You can specify the name for the NC-500 as
the client name.
From the “System” → “Ethernet Settings” →
“Client” setup menu, select “ClientName”
using the Cursor
/ button. Then press the
SELECT button.
Press the DISPLAY button to select the
character type to enter. Each time you press
the DISPLAY button, the character type
cycles. Press the Cursor
/ button
repeatedly to select your desired character.
Press the SELECT button to enter the selected
character.
After entering the client name, press the
SETUP button to confirm the new setting.
• Specify Port number
From the “System” → “Ethernet Settings” →
“Proxy Setup” setup menu, select “Port No”
using the Cursor
/ button. Then press the
SELECT button.
Enter the port number using the Cursor / /
/ button, and then press the SELECT
button to confirm the new setting.
• Specifying proxy URL
From the “System” → “Ethernet Settings” →
“Proxy Setup” setup menu, select “URL”
using the Cursor
/ button. Then press the
SELECT button.
Select the character to enter using the Cursor
/ / / button, then press the SELECT
button to enter the selected character.
After completing entering the Proxy Address,
press the SETUP button.