OpenText Tableau Forensic TX1 Imager
The Information Company 69
5. To change or add the destination drive(s) tap the 3 or Destination(s) heading. From
the destination list modal that is displayed, select one or more drives from the list.
For eac
h selected destination drive, a Job type panel expands below the Drive tile.
Select the Clone radio button to clone to the destination or select the Image radio
button to image to the destination.
For clones, the option is displayed to trim the destination drive to be the same size as
the source using a DCO or AMA.
Note: The trim feature is only available for SATA destinations that support DCO or
AMA.
For images, the default destination directory path is displayed. To change the
destination base directory, tap the orange Directory label to enter a Browse modal
where you can select a different destination base directory, create and select a new
directory, or delete a directory. Tap one or more of the four buttons (Date and Time,
Model, Serial, or Case ID) under the directory path to add variables as names for a
destination sub-directory. Each variable can only be selected once. Underscores are
printed as separators between multiple variable names.
Copyright © 2022 Open Text. All rights reserved. Trademarks owned by Open Text.
To Next Page
Loading...