Opticon MDI-4100 - Page 24

MDI-4000 Series Serial Interface Manual
12
Example Custom Command Line Settings
Setting
Command
Enable Fast Boot Mode.
[EFXQ1
Enable ACK/NAK.
WC
Disable 2D Menu Barcode.
[D1Z
Enable Upside Down Image.
[EFV[E8I
Set Baud Rate to 115200 bps.
SZ
Enable Low Power Standby.
[EB8
Set Low Power Standby Transition Time to 2 seconds.
[EBAQ0Q0Q0Q2
Reboot the scan engine.
RV
Initialize the scan engine.
U2
Example packets sent to configure Custom Command Line Settings:
<ESC>[EFY'[EFXQ1WC[D1Z[EFU[E8ISZ[EB8[EBAQ0Q0Q0Q2'<CR>
<ESC>RV<CR>
<ESC>U2Z2<CR>
You can also output currently configured commands in Custom Command Line Settings.
Output Commands
Command
Description
[EFZ
Output configured commands in custom command line
Example output:
[EFXQ1WC[D1Z[EFU[E8ISZ[EB8[EBAQ0Q0Q0Q2
Note: If no Custom Command Line commands have been configured, the scan engine will not
send anything.
3.4 Fast Boot Mode
Fast Boot Mode reduces the time from power-on to ready. When this mode is used, all settings
saved with the Z2 command are ignored and the scan engine starts with the default settings.
For more information, see “Factory Default Settings” on page 10.
You can change the default settings with Custom Command Line commands. For more
information, see “How to Permanently Change the Factory Default Settings” on page 11.
Fast Boot Mode Enable/Disable
Command
Description
Default
[EFX
Get the current mode (*)
Q0
Disable Fast Boot Mode
✓
Q1
Enable Fast Boot Mode
* The return values are: Disable Fast Boot Mode<CR>, Enable Fast Boot Mode<CR>.