ASCII128 character
Function character (FNC1 – 4)
Code set selection character (A, B, C, and Shift)
GS1 Conversion
Disable/Enable GS1-128 GS1 conversion is configurable. For more information, see “GS1
Conversion” on page 55.
Code 128 Concatenation
When concatenation is enabled, scanned data is added to the end of the data buffered in the
scan engine, and then all of the data in the buffer is sent. You can concatenate a maximum of
400 characters.
The read time is updated each time the scan engine scans a barcode label. If the barcode is not
read within the read time, the buffered data is discarded. For more information, see “Read
Time” on page 49.
If the Code128 barcode contains an FNC2 character as the leading digit, you cannot enable
concatenation. To concatenate data, you need to omit the leading FNC2 character.
Code 128 Optional Settings
To Next Page
Loading...
Need help?
General
