during the data output. When buffer mode is disabled, the scan engine stops other operations
until it finishes outputting decoded data.
Data Buffer Mode Commands
5 Power Management and Timing
These power management and timing configurations are available:
• Power Mode Transition
• Current Consumption
• Low Power
• Recovery from Low Power Mode
• Power ON/OFF Timing
• Read Timing
5.1 Power Mode Transition
*1
These options are available to reduce start-up time: Fast Boot and Normal Boot.
*2
When Low Power Standby is enabled, the scan engine automatically enters the Low Power state after power on.
*3
The Hardware Trigger (or Z Trigger) command moves from the Low Power state to the Read state.
Figure 22: Power Mode Transition
To Next Page
Loading...
