Opticon MDI-4100 - Page 77

MDI-4000 Series Serial Interface Manual
65
EAN/JAN-13 Settings
Setting
Options
Character set
Numeric (0 - 9)
Number of digits
13 digits (12 digits plus a 1-digit CD) fixed length
EAN/JAN-13 Transfer Data Format
Digit
Description
Data
12 digits
Check Digit (CD)
1 digit
6.3.2.1 EAN/JAN-13 Add-On 2 Digits/5 Digits
EAN/JAN-13 Add-On 2 Digits/5 Digits is an EAN/JAN-13 barcode with an additional 2-digit or
5-digit barcode to the right of the main barcode. When add-on digits are enabled, the add-on
code must be within the reading range for the barcode to be successfully read. If the add-on
code is not within the reading range, after an add-on waiting time the scan engine reads the
barcode as UPC or EAN.
Note: Reading response decreases when add-on digits are enabled and only UPC or EAN
barcodes are read.
EAN/JAN-13 Add-On 2 Digits Transfer Data Format
Digit
Description
Data
12 digits
CD
1 digit
Add-On
2 digits
EAN/JAN-13 Add-On 5 Digits Transfer Data Format
Digit
Description
Data
12 digits
CD
1 digit
Add-On
5 digits
EAN/JAN-13 CD Transfer
Lets you configure the EAN/JAN-13 CD.
EAN-13 Forced Add-On
You can enable EAN-13 Forced Add-On so that EAN-13 barcodes with specific leading 3-digits
(378/379/529/414/419/434/439/977/978) are not read.
Note: An EAN-13 barcode that has leading 3-digits does not have add-on digits.