Orbit Reader 20 Plus – User guide Version 1.0
Orbit Research Confidential and Proprietary Information 36
In” search files”, the Reader moves from reading files to searched text and
displays it at the beginning of the display line. If the text is not found, then the
Reader displays “Not found” and gets back to its previous position. While
searching through large documents, the Orbit Reader 20 Plus displays “Busy”
while conducting the search.
To repeat a search moving forward towards the end of the file, press Dot 8 +
Right Arrow.
To repeat a search moving back towards the beginning of the file, press Dot 8 +
Left Arrow.
14.4 Braille Pacer (Auto-Scroll)
The Braille Pacer feature is available in the Reader and lets you set a reading
pace for the display to automatically advance.
The pace can be adjusted during reading by pressing the space and up-arrow
key to increase the speed (i.e. a faster advance rate) or the space and down-
arrow key to decrease the speed (i.e. a slower advance rate). Pressing these
keys once increases or decreases the speed in one-second steps. You can set
the scrolling speed from 1 to 20 seconds depending upon your reading speed.
Many users might like to have finer control of the speed and this can be achieved
by pressing the space bar, dot 7 and up or down arrow keys. The fine control
increases or decreases the speed in steps of one-tenth of a second.
The default speed is 10 seconds. You can review the current scroll rate from the
menu, but it can be changed only while reading. The current scroll rate is not
displayed when auto-scrolling. However, when the auto-scroll is stopped and the
scroll rate is changed, the scroll rate will be displayed by the message “xx.y sec
scroll rate”. You can use all the reading navigation commands during the Braille
Pacer mode as well.
To Next Page
Loading...
Need help?
General