Oriental motor DSC Series - Product Functions; List of Available Functions

Function
−25−
7 Function
7.1 Functions list
The following functions are available for this product.
Function Description
Reference
page
Display
Rotation speed
Displays the rotation speed of the motor output shaft.
28
Displays by the rotation speed of the gearhead output
shaft.
Fixes the display of the lowest digit to "0."
29
Other Speed
Displays by the transfer speed of the conveyor drive.
Displays by the increased speed.
Operation data No.
Displays the operation data number.
28
I/O signals
Checks the ON/OFF status of the input signals.
Checks the ON/OFF status of the output signals.
Alarm
Checks the alarm information.
Checks the alarm records.
Warning
Checks the warning information.
Checks the warning records.
Basic
Setting the rotation speed
Sets the rotation speed.
28
Sets to change the speed while the motor is rotating.
20
Set the rotation speed using the external
potentiometer.
20
Set the rotation speed using the external DC voltage.
Selects the setting voltage of the rotation speed.
(0 to 5 VDC or 0 to 10 VDC)
29
Checks the setting value (voltage) from outside.
28
Setting the acceleration/
deceleration time
Sets the acceleration time and deceleration time.
Multi-speed operation
Operates in two or more speeds.
23
Test operation
Starts and stops the motor.
18
Alarm reset
Resets the alarm that is present.
28
Application
Action for when the power
is turned on
Starts or stops the motor by ON-OFF control of the
AC power supply.
29
Offset setting
Adjusts the speed difference when performing multi-
motor control.
24
Limiting the setting range
Limits the setting range of the rotation speed
(upper limit, lower limit)
30
Changing the function for
I/O signals
Changes the functions of the input signals
(6 signals).
31
Changes the functions of the output signals
(2 signals).
Changing the rotation
direction
Changes the rotation direction when the FWD input is
turned ON.
29
"Motor lock" alarm
Changes the alarm detection time.
Initialization
Operation data
Initializes the operation data.
28
Parameter
Initializes the parameter.
29
Operation lock function
Blocks so that the data will not be changed.
31