Oriental motor DSC Series - Product Preparation and Identification; Checking the Product Contents; Identifying Product Model Numbers

Preparation
−5−
3 Preparation
3.1 Checking the product
Verify that the items listed below are included. Report any missing or damaged items to the branch or sales ofce
from which you purchased the product.
Verify the model number of the purchased product against the number shown on the package label.
Check the model number of the motor, gearhead and speed controller against the number shown on the nameplate.

Motor ......................................................... 1
unit
(The combination types come with the motor and gearhead
pre-assembled)

Speed controller ........................................ 1
unit

Capacitor .................................................. 1 pc

Capacitor cap ............................................ 1 pc

Connection cable ...................................... 1 pc
(Only models with a supplied connection cable)

External potentiometer .............................. 1 pc
(Only models with a supplied external potentiometer)

OPERATING MANUAL (this document) ... 1 pc
[Supplied with only the models of the combination type]

Hexagonal socket head screw set........1 set
(Hexagonal socket head screw, at washer,
spring washer, 4 pieces each, parallel key 1 piece)
3.2 How to identify the product model
DSC I 4 25 JA - 50 -3 V
Number: Length (m) of a supplied connection cable
-1: 1 m (3.3 ft.), -2: 2 m (6.6 ft.), -3: 3 m (9.8 ft.)
Blank: Without a supplied connection cable
Number: Gear ratio for combination type
A: Round shaft type
Power supply voltage JA: Single-phase 100 V UA: Single-phase 110 V, 115 V
JC: Single-phase 200 V EC: Single-phase 220 V, 230 V
Output power 6: 6 W, 15: 15 W, 25: 25 W
40: 40 W, 60: 60 W, 90: 90 W
Frame size 2: 60 mm (2.36 in.) sq. 3: 70 mm (2.76 in.) sq.
4: 80 mm (3.15 in.) sq. 5: 90 mm (3.54 in.) sq.
Series name
Motor Type I: Induction Motor
Motor and speed controller package
Motor
4 I K 25 U GV - JA
U: For the motor and speed controller package
Power supply voltage
Pinion shaft type: GV, GVH, GVR
Round shaft type: A
Output power
K䊡 Series
Frame size
Induction Motor
Gearhead
Speed controller
4 GV 50 B
Pinion type
Frame size
Gear ratio
Identification code
DSC - U
Series name
For the motor and speed
controller package
Blank: Without a supplied external potentiometer
V: External potentiometer (supplied)