Oriental motor DSC Series - X84; Removing;Installing the Gearhead; X84; Installing the Round Shaft Type; X84; for the Motor Equipped with Cooling Fan (90 W)

Installation
−9−

Removing/Installing the gearhead
The gearhead or the outlet position of the motor lead wires can be changed.
•
Removing the gearhead from the motor
Remove the gearhead by unscrewing the hexagonal socket-head screws holding the gearhead to the motor
(2 locations).
Hexagonal socket-head screw
(2 locations)
Illustration shows the view from motor case side.
Gearhead
model
Screw size
Tightening torque
[N·m (lb-in)]
2GV
o
B
3GV
o
B
4GV
o
B
M2.6 0.4 (3.5)
5GV
o
B
5GVH
o
B
5GVR
o
B
M3 0.6 (5.3)
•
Combining the gearhead to the motor
Using the pilot sections of the motor and gearhead as guides, slowly rotate it clockwise/counterclockwise to prevent the pinion
of the motor output shaft from contacting the side panel or gear of the gearhead. Also conrm that no gaps remain between the
motor and gearhead.
An O-ring is attached to the ange of the motor. Do not pinch the O-ring when assembling the motor and gearhead. Pinching the
O-ring causes a grease leak from the gearhead.
Output shaft (pinion) of motor
Gearhead
Pilot end face
Pilot section
Flange
Motor
Note
Do not forcibly assemble the motor and gearhead. Also, do not let metal objects or other foreign
matters enter the gearhead. The pinion or gear of the motor output shaft may be damaged,
resulting in noise or shorter service life.

Installing the round shaft type
Drill holes in the mounting plate, and secure the motor using the hexagonal socket head screws (not supplied) through four
mounting holes.
Install it so that no gaps remain between the motor mounting surface and mounting plate.
Motor
Mounting plate
Motor model Screw size Tightening torque
2IK
M4
1.8 N·m (15.9 lb-in)
[1.4 N·m (12 lb-in)]
3IK
M5
3.8 N·m (33 lb-in)
[3.0 N·m (26 lb-in)]
4IK
5IK
M6
6.4 N·m (56 lb-in)
[5.0 N·m (44 lb-in)]
The brackets [ ] indicate the value for stainless steel.

For the motor equipped with cooling fan (90 W)
When installing a motor with cooling fan onto a device, leave 10 mm (0.39 in.) or more behind the fan cover or open a ventilation
hole so that the cooling inlet on the back of the motor cover is not blocked. This is common to both the combination type and
round shaft type.