Preparation
−7−
3.4 Names and functions of parts
Motor
Motor
Protective Earth Terminal
Gearhead
Output shaft
Mounting holes
(four locations)
Rear view of the motor
Tachogenerator
Speed controller
Display
Operation keys
POWER LED
(Green)
Main circuit connector
(CN1)
ALARM LED
(Red)
DIN lever
Control circuit connector
(CN4)
Motor connector
(CN3)
Protective film
(Use after removing the protective film.)
Operation panel
Sink logic/Source logic
select switch (SW1)
Name Description
Reference
page
Operation
panel
Display
(4-digit LED)
The rotation speed, parameter, alarm and others are shown on the
display.
p.26
Operation keys
These keys are used to switch the operation mode, set the operation
data or change the parameter.
POWER LED
(Green)
This LED is lit while the AC power is supplied to the speed controller. p.18
ALARM LED
(Red)
This LED blinks while an alarm generates. p.32
Motor connector
(CN3)
Connects the motor connector.
p.13
Main circuit connector
(CN1)
Connects the AC power supply, capacitor and FG.
Control circuit connector
(CN4)
Connects the control DC power supply and I/O signals.
Sink logic / Source logic
select switch (SW1)
This switch is used for switching the input signal between sink logic
and source logic modes.
p.17
DIN lever
Mounts the speed controller to a DIN rail.
The speed controller can be mounted using screws.
p.11
To Next Page
Loading...
