Orthofab Tango - Dynamic Backrest; Dynamic Backrest Installation

4 SETUP INSTRUCTIONS
inc All rights reserved 18
4.4 DYNAMIC BACKREST
4.4.1 DYNAMIC BACKREST INSTALLATION
POSITION ANGLE
1 90°
(std)
2 95°
3 100°
4
NON-
AVAILABLE
5
NON-
AVAILABLE
6
NON-
AVAILABLE
7
NON-
AVAILABLE
Figure 6-A: Dynamic backrest angles adjustment positions.
NOTE :
The way to change the dynamic backrest angle, is the same as per section
4.5.1, the only difference with the dynamic backrest is to don’t forget to move the nylon
washers (C) following the new angle position (see; figure 6-B).
Consult the figure 6-A above to know the possible adjustment angles and to
tighten the screws at 20 pounds/inch
.
It is important to use only the 1 to 3 positions of the figure 6-A
table above, to not damage the dynamic backrest system.
The adjustments of your wheelchair must be made by
a health care professional. Inadequate adjustments can cause
wounds and/or damage to the user, the caregiver, the
wheelchair or the environment.