Orthofab Tango - Cable Winder Installation

4 SETUP INSTRUCTIONS
inc All rights reserved 38
Figure 19 : Motorized tilt mechanism control box installation.
4.7.6 CABLE WINDER INSTALLATION
1. Use the last hole, on the seat structure frame (F), this hole will be use to fix the
charger cable winder (see; figure 20).
2. Fix the charger cable winder as shown at figure 20, take the (A) screw, the (B)
washer, the (E) winder, the (D) saddle and the (C) nut, using (2) 7/16" key, tighten
the assembly firmly on the seat structure frame.
3. Wind up the charger cable in the charger cable winder (E) to prevent any damage
to the cable during use.
Figure 20 : Charger cable winder installation.