4 SETUP INSTRUCTIONS
inc All rights reserved
43
b)
QUICK RELEASE AXLE :
1. Push the (A) button and pull the wheel towards you. Grab the wheel from its
center (see; figure 24-B) ;
2. To replace, push the (A) button and insert the axle in the housing. Make sure that
the axle is locked in position in the housing by the blocking pins (B).
Figure 24-B: Quick release axle.
NOTE : If the axis does not locked, it requires an adjustment.
To do it :
1. Remove the axis from the housing ;
2. Use a 7/16” key, to maintain the end of the axis (A) ;
3. Use a 3/4” key, to tighten or loosen (B) nut slightly ;
4. Insert the axis in the wheel and carry out a test. (It is always preferable to
have a small side play, once the axle is locked ± 1/64”).
Figure 25 : Quick release axle adjustment.
Make sure that the two (2) blocking pins of the quick
release axle are released before using the wheelchair. The
blocking pins MUST exceed the housing for a perfect fit.
Keep the axle and the blocking pins clean.
To Next Page
Loading...