4 SETUP INSTRUCTIONS
inc All rights reserved
51
For the 12 inches rear wheels installation (see; figure 29):
1- Remove rear wheels (see; section 5.6.1) ;
2- Remove the rear wheels axle (see; section 4.9.2, figure 27-A) ;
3- Insert the side tubing frame extension in the side tubing ;
4- Take a "Foot brake system assembly" and install it on the frame, using (2) two
7/16" key to tighten the (A) screws and (B) nuts
(see; figure 29) ;
5- Install the 12 inches rear wheel as same as a big radius rear wheel and follow the
instructions of section 4.9.1 depending of which type of axle used.
6- Remove the (2) two parking brakes of the big radius rear wheels (see; section 4.10)
using a 1/2" key.
NOTES:
1) There is no adjustment to do between the foot brake system
assembly and the 12 inches rear wheel. Everything should be
functional upon the final set up.
2) It will be not possible to install 12 inches rear wheels on a
wheelchair equipped with a mid-wheel configuration.
3) On a wheelchair equipped with 12 inches rear wheels and anti-
tippers, it will be not possible to have a foot brake system
assembly installed.
4) It is possible to have 12 inches rear wheels with standard hand
brake system (see; figure below).
To Next Page