Otodynamics Otoport Flex - Page 206

CHAPTER TWENTY-SEVEN
Technical specications
206
Technical specications
27.2 Electromagnetic Compatibility: Otoport
The Otoport should be put into service according to the EMC (Electromagnetic
Compatibility) information provided here.
Portable and mobile RF (Radio Frequency) communications equipment can a󰀨ect
the operation of the Otoport. In particular, mobile telephones (‘cellphones’) should
not be operated within 3.3m of the Otoport.
The use of probes, chargers and connection cables other than those supplied by
Otodynamics Ltd, and specically for use with the Otoport may result in increased
emissions or decreased immunity of the Otoport.
Guidance and manufacturer’s declaration – electromagnetic emissions
The Otoport is intended for use in the electromagnetic environment
specied below. The user of the Otoport should ensure that it is used in such
an environment.
Emissions test Compliance Electromagnetic environment
- guidance
RF emissions Group 1 The Otoport uses RF energy only for
CISPR 11 its internal function. Therefore, its RF
emissions are very low and are not
likely to cause any interference in
nearby equipment.
RF emissions Class B The Otoport is suitable for use in all
CISPR 11 establishments, including domestic
establishments and those directly
connected to the public low-voltage
power supply network that supplies
buildings used for domestic purposes
Harmonic emissions Class A
IEC 61000-3-2
Voltage uctuations/ Complies
icker emissions
IEC 61000-3-3
The Otoport should not be used adjacent to or stacked with other equipment and
that if adjacent or stacked use is necessary the Otoport should be observed to verify
normal operation in the conguration in which it is used.