Panasonic AFPX-C30T - Page 209

Option setting
Item
Description
Default
Response timeout
(When selecting the
computer link only)
Set the wait time for the response. 5000 ms
End code
This is the code for the AFPX-COM5 to confirm the end of the
message (data) to be received from the FP-X.
CR, CR+LF or NONE can be selected.
Reception continues until the end of the message (CR, CR+LF)
will be received. When selecting NONE, the end code is not
confirmed.
CR
Judgment time without
termination
Set the wait time for the end code.
If the next message (data) is not received within the judgment
time without termination (ms) after the last received message
(data), the AFPX-COM5 judges that is no termination, and
performs the following operation.
(End code: when selecting CR, CR+LF)
The received message (data) is discarded. For TCP, the
connection is disconnected.
(End code: when selecting NONE)
The message (data) is transmitted to the connected destination.
20 ms
Network
informa-
tion
Information
area first No.
Set the area of DT to be used for the network information and
connection information.
Setting range: 3000 to 12000
10000
Network
information
notification
When the power turns on, the network information will be
notified to the FP-X.
Invalid
Network
information
confirmation
When using the computer link and client, the network
information can be confirmed.
Invalid
Connection
information
confirmation
When using the computer link and server, the connection
information can be confirmed from the LAN side.
Invalid
Target IP
address
for unit
No.
Destination
unit No. and
IP address is
specified.
A command is transmitted to the IP address corresponding to
the unit number.
Invalid
Unit No.
Select a unit number.
Can be selected from the range of 1 to 99.
Invalid
IP address Set an IP address. 192.168.1.100
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.clrwtr.com - Email: info@clrwtr.com