Setting to allow the access to the program by inputting a password
As the dialog box is shown, select as below.
Digit number:
Select “4 digits” or “8 digits”.
Operation Mode:
Select “Access”.
4 digits (or 8 digits) password:
Input a password to be set.
Click “Settings”.
The setting has completed.
Note:
If the power supply of the PLC is turned on/off with the setting that the access is allowed, the setting will
be that the PLC is protected again.
How to cancel the password setting
Following two methods are available to cancel the password setting.
Cancels the registered password to be specified.
All programs are retained.
Force cancel
Erases all programs and security information to
cancel the setting forcibly.
All programs are deleted.
(The upload protection setting is
also deleted.)
Releasing the protection of PLC (Programs are retained.)
As the dialog box is shown, select as below.
Digit number:
Select “4 digits” or “8 digits”.
Operation Mode:
Select “Unprotect”.
4 digits (or 8 digits) password:
Input a password to be set.
Click “Settings”.
Click [OK].
Note) The protection cannot be released if the access is not allowed.
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.clrwtr.com - Email: info@clrwtr.com
To Next Page
Loading...
