2. Under [Viewnetcam.com Registration], select [Register with Viewnetcam.com].
3. Click [Save].
4. When [Setup completed] is displayed, click [Go to Viewnetcam.com Registration page].
• The Viewnetcam.com website is displayed. Follow the on-screen instructions to register with
Viewnetcam.com.
• When [Setup completed] is displayed, the addresses for accessing the camera over the LAN and over
the Internet are displayed.
5. Click [To Single Camera page].
Configuring the camera to use Viewnetcam.com from the [DynamicDNS]
page
1. Click the [Setup] tab.
2. On the left side of the screen under [Basic], click [DynamicDNS].
3. Select [Viewnetcam.com], then click [Next].
4. Click [Save].
• When setup is complete, [Success!] is displayed.
106 Operating Instructions
4.2.1 Configuring the Camera to Use Viewnetcam.com
To Next Page
Loading...
