2.5.2 Sending Trigger Notifications by HTTP
The following screen is displayed while configuring the camera to buffer or transfer images by built-in sensor
or external sensor, or by detection (see Page 54) if you select [Send HTTP Notification]. Follow the procedure
below to send trigger notifications by HTTP.
Note
• If your camera’s network uses a proxy server, the appropriate proxy server settings must be made on
the [Network (IPv4)] page in order for images to be transferred by HTTP (see Page 118).
1. Set the following parameters as desired.
a. Enter the URL
*1
of the HTTP server (max. 255 characters).
• An IPv6 address can be specified; note that the IPv6 address must be enclosed in brackets.
b. Enter the port number used by the server. (Port 80 is normally used for HTTP.)
c. Enter the login ID
*2
(user name) required to access the server (max. 63 characters).
d. Enter the password
*2
required to access the server (max. 63 characters).
e. Enter the path
*2
to the desired CGI file on the server.
2. Click [Save], then click [Go to Trigger page].
*1
[Space], ["], ['], [&], [<], and [>] cannot be entered.
*2
["] cannot be entered.
72 Operating Instructions
2.5.2 Sending Trigger Notifications by HTTP
To Next Page
Loading...
