1.2.3 Limiting the Pan/Tilt Range
You can limit the maximum pan and tilt range of the camera’s lens.
Note
• This feature is available to the camera administrator only.
1. Click the [Pan/Tilt Range] button in the operation bar.
2. Set the pan and tilt range as desired.
a. Aim the camera to the leftmost point you want to allow to be seen, then click .
b. Aim the camera to the rightmost point you want to allow to be seen, then click .
c. Aim the camera to the uppermost point you want to allow to be seen, then click .
d. Aim the camera to the lowermost point you want to allow to be seen, then click .
3. Click [Save].
Note
• Even if you limit the pan and tilt range, you can view the entire range of the camera’s pan and tilt range
while setting the pan and tilt range on this page.
• When you click the [Pan/Tilt Range] button, the refresh rate changes to MJPEG.
• You can aim the camera by clicking on the desired navigation button, or by using the click to center
feature.
28 Operating Instructions
1.2.3 Limiting the Pan/Tilt Range
To Next Page
Loading...
