3.2 Viewing Still Images on Your Mobile Phone
Still images from the camera can be viewed with a compatible mobile phone.
A. Press [4] or [6] to pan the lens left or right, respectively, or
press [2] or [8] to tilt the lens up or down, respectively.
When the lens has reached the end of its pan or tilt range,
the corresponding number will not be displayed.
B. Press [5] to refresh the image.
C. Press [0] to toggle between the available image
resolutions (192 ´ 144 and 320 ´ 240). You can set the
default image resolution for when viewing with your mobile
phone (see Page 159).
D. Select [Home Position] to move the lens to the home
position.
E. Press [1], [3], [7] or [9] to move the lens to the first four
presets (presets 1–4).
F. For presets 5–8, select the corresponding preset name to
move the lens to the desired position.
G. BL-C230 only: Controls the output signals of the external
I/O interface (see Page 168).
H. Select [Alarm Log] to view the last 50 external sensor and
motion detection trigger logs (see Page 94).
• You must be logged in to the camera as an
administrator to use this feature.
I. Select [Buffer/Transfer] to view the image buffer and
transfer control page (see Page 95).
• You must be logged in to the camera as an
administrator to use this feature.
J. Select [Privacy Mode] to turn privacy mode on. (You may
be asked to enter the administrator user name and
password.) To turn privacy mode off, access the camera
again and select [Disable Privacy Mode].
• You must be logged in to the camera as an
administrator to use this feature.
Note
• When accessing the camera as a general user or as a guest user, certain features may be disabled
according to the [Access Level] set for the user (see Page 152 and Page 155).
• If the camera is configured to allow access from guest users (i.e., anonymous users; see Page 155),
users can access the camera’s mobile phone pages using a mobile phone or PC without entering a
user name or password. If guest user access is permitted, you can log in as the administrator by
selecting [Alarm Log], [Buffer/Transfer], or [Privacy Mode], and then entering the user name and
password when the authentication dialog is displayed.
92 Operating Instructions
3.2 Viewing Still Images on Your Mobile Phone
To Next Page
Loading...
